D-FS100LD/20C

D-FS100LD/20C系列直流漏电流传感器是应用磁调制原理研制而成的一种新型电流传感器，其小电流的稳定性好，初级与次级之间高度绝缘，抗干扰能力强。信号变换后能够直接被 PLC, 二次仪表等各种采集装置直接采集和接受，广泛用于讯号系统、线路检测、漏电监测系统、电流差值测量。 D-FS100LD/20C series DC leakage current sensor is a new type of current sensor developed by magnetic modulation principle. It has good stability of small current, high insulation between primary and secondary, and strong anti-interference ability. After signal conversion, it can be directly collected and accepted by PLC, secondary instrument and other acquisition devices, and is widely used in signal system, line detection, leakage monitoring system, current difference measurement.

Send Inquiry

Download

Product Introduction

D-FS100LD/20C系列直流漏电流传感器是应用磁调制原理研制而成的一种新型电流传感器,其小电流的稳定性好,

初级与次级之间高度绝缘,抗干扰能力强.信号变换后能够直接被 PLC, 二次仪表等各种采集装置直接采集和接受,广泛用于讯号系统,线路检测,漏电监测系统,电流差值测量.

D-FS100LD/20C series DC leakage current sensor is a new type of current sensor developed by magnetic modulation principle. It has good stability of small current, high insulation between primary and secondary, and strong anti-interference ability. After signal conversion, it can be directly collected and accepted by PLC, secondary instrument and other acquisition devices, and is widely used in signal system, line detection, leakage monitoring system, current difference measurement.

电参数/Electrical characteristics

D-FS100LD/20C系列	001LD	005LD	010LD	020LD	030LD	040LD	050LD	100LD
额定电流IPN(mA) Primary nominal input current	1	5	10	20	30	40	50	100
测量范围IP(mA) Measuring range ofprimary current	0... ±1.5	0... ±7.5	0... ±15	0.. ±30	0... ±45	0.. ±60	0... ±75	0.. ±150
输出电压Vo Output voltage	输出额定值±5V, 对应原边额定电流 The output rating is ±5V, corresponding to the rated current of the primary side
精度Ae Precision	±1%
电源电压Vco Supply voltage	± 12...15V(±5%)
绝缘电压V Insulation voltage	在原边与副边电路之间：50Hz,1min,3KV Between the primary and secondary side circuits: 50Hz,1min,3KV
失调电压Voff Offset voltage	当原边电流IN=0时,最大值：±30mV When the primary current IN=0, the maximum value is ±30mV
温漂VoT Thermal drift of V0	最大值：±1mV/℃ Maximum value: ±1mV/℃
线性度Le Linearity	≤±1%
反应时间Tres Response time	≤20ms
工作温度TA Ambient operating temperature	-10℃...+85℃
贮存温度T Ambient storage temperature	-40℃..+85℃
负载电阻RL Load resistance	>2KΩ

外形结构(mm)/Dimensions of drawing(mm)

product-1355-649

使用说明/Remarks：

当待测电流从传感器穿过,即可在输出端测得电压大小;(注意：错误的接线可能导致传感器损坏)

When the current to be measured passes through the sensor, the voltage can be measured at the output end. (Note: Incorrect wiring may cause sensor damage)

传感器的输出幅度可根据用户需要进行适当调节;

The output amplitude of the sensor can be adjusted according to the needs of the user;

可按用户需求定制不同额定输入电流和输出电压的传感器.

Sensors with different rated input current and output voltage can be customized according to user requirements.

Hot Tags: d-fs100ld/20c, China d-fs100ld/20c manufacturers, suppliers, factory, Split Core Hall Effect Current Snesor SZ140KB, Hall Effect Sensor SZ4131, Closed Loop Hall Effect Current Sensor, Bending Beam Type Weighing Module, Hall Effect Current Sensor SZ1KD12, Safty Protection Divice

D-FS100LD/40

D-FS050LD/60